Connecting To An Atem Switcher; Connecting A Monitor - Blackmagic Design Atem Installationsanleitung

Connecting to an ATEM Switcher

Your ATEM Microphone Converter supports digital audio with the MADI protocol, also
known as Multichannel Audio Digital Interface. MADI is popular with most professional audio
manufacturers, broadcasters and high end recording facilities. These MADI ports have robust
BNC connectors and transmit audio data over 75 ohm coaxial cables up to 100 meters long.
Connect your converter's MADI BNC output to the MADI input on your ATEM switcher.
ATEM switcher models that support MADI include ATEM 4 M/E Constellation HD,
ATEM Constellation 8K and ATEM Television Studio HD8 ISO.
REF OUT TIMECODE OUT MADI OUT
USE ONLY WITH A 250V FUSE
12-30V 6A REF IN TIMECODE IN MADI IN
You can find more information about controlling audio levels and enhancing the quality
of your audio in the manual for your ATEM switcher.

Connecting a Monitor

Connect an HDMI television or monitor into the converter's HDMI output.
This video output lets you view the levels of each channel, plus a continuously updating
waveform showing audio peaks over a 60 second duration. You can also visually confirm
that phantom power is activated and if inputs are set to mic or line level audio.
For more details about the monitor output and all the information it displays, refer to the
'using the monitor output' section.
MADI OUT to MADI IN
1 2 3 4 5
USB A USB B REMOTE TALKBACK SDI OUTPUTS
1 2 3 4 5
ETHERNET SDI INPUTS
ATEM Television Studio HD8
6 7 8
L L
AUX 1 PROGRAM
6 7 8
R R
AUX 2 MULTIVIEW MULTIVIEW CONTROL OUT STUDIO OUT
Monitor Out
PUSH PUSH PUSH
L
R
CH 1 CH 2
STEREO IN ANALOG AUDIO IN TALKBACK
Getting Started 7