Reefbeat Device Manager - Red Sea ReefRun Dual Controller Benutzerhandbuch

ReefBeat Device Manager

The Device Manager is accessible from the Page menu in both the
ReefBeat homepage and the device settings page, and contains a list of
all the Red Sea connected devices that are installed on each aquarium.
The devices are listed according to type and in the order in which they
were added to the aquarium. Tapping the individual device opens a list
of available actions for the specific device. Tapping the 3-dot menu for
the device type opens a list of actions that can be done simultaneously
for all devices of the same type.
Turn OFF / Turn ON
The device can temporarily be turned off/on without physically
unplugging it or losing any of its settings.
For individual units: Device manager > Device line menu > Turn OFF / ON.
For device type: Device manager > Device type menu > Turn OFF / ON
Reconnecting a device to the ReefBeat Cloud
If you have received a disconnected notification for your device, it may
need a reboot to reconnect it.
If the settings indicator LED on the device is ON click the Reboot button
from the device manager: Device Manager > Device Line menu > Reboot.
If the settings indicator LED is OFF pressing the settings button on the
device for less than 2 seconds will initiate the Reboot enabling the
device to reconnect to the home network. If this does not resolve the
issue, check that the network is available.
Firmware Updates
From time to time, you may receive a notification that a new firmware
version is available for your device. It is important to keep your device
firmware updated to ensure compatibility with updates to the ReefBeat
App.
Individual units can be updated: Device manager > Device line menu >
Firmware Update.
To update all units simultaneously: Device manager > Device type
menu > Firmware update
Do not unplug a device while it is downloading and installing the new
firmware.
Device Manager > Device Line menu > About - will show the currently
installed firmware version. When the firmware update is complete, the
"About" page will show the new version as the current version along
with the date and time that the update was performed. All your previous
settings will remain as before. If the firmware update is not successful,
the device will automatically revert to the previous version. Repeat the
process a few minutes later.
If your device does not seem to be performing correctly after the update,
reboot the unit by pressing the settings button for less than 2 seconds.
Deleting a device
To remove a device from an aquarium, delete the unit from the
ReefBeat App:
Device Manager > Device Line menu > Delete.
Deleting the device before it is switched off will prevent unnecessary
notifications that it is disconnected from the cloud.
Red Sea ReefRun ® Dual Controller
ENG
17