Red Sea ReefRun Dual Controller Benutzerhandbuch Seite 10

Red Sea ReefRun ® Dual Controller
Settings Button – Function
If indicator LED is off (ReefRun Dual Controller Wi-Fi is off): Pressing
button for 5 seconds (until double blink) activates Wi-Fi AP mode.
If indicator LED is blinking (ReefRun Dual Controller Wi-Fi is in AP mode):
Pressing button for 5 seconds (until double blink) switches Wi-Fi off.
If indicator LED is on (ReefRun Dual Controller Wi-Fi is connected
to a Wi-Fi network): Pressing button for 5 seconds (until double blink)
disconnects the ReefRun Dual Controller from the network and switches
it to Wi-Fi AP mode. (Note: before disconnecting a ReefRun Dual
Controller from a network, delete the specific ReefRun Dual Controller
from the ReefBeat App via the Device Manager).
Note: All settings are retained and can be restored when reconnected to
the ReefBeat.
Reboot: Pressing and releasing the button for less than 2 seconds will
cause the unit to shut down and restart. Wi-fi and pumps will stop
momentarily during the process. User settings are not affected.
Clear Settings: Pressing the button for 15 seconds (until double blink)
deletes all user settings and switches the Wi-Fi to AP mode. Complete
the reset process by disconnecting and reconnecting the DC power.
10
Pause/Resume and Flow-intensity Dial
After a pump has been set up on the RRDC the Pause/Resume and
Flow-intensity Dial becomes active.
When a pump is running, a short press on the dial will switch the pump
off. A second short press will switch the pump back on and resume
whatever intensity is currently scheduled for the pump.
If a pump is in a malfunction state, and after the issue has been
resolved, a short press on the dial will restart the pump.
To manually change the flow intensity for a pump from the controller,
press on the dial for 5 seconds until the indicator LEDs around the dial
start to blink. While the LEDs are blinking, rotate the dial clockwise /
counter-clockwise to increase / decrease the flow intensity. When you
have reached the desired new intensity press on the dial for 5 seconds
to save the new settings.
Note: In the App, flow intensity can be set in increments of 1%. The LED
indicators on the dial show the intensity in 10% bands. When rotating
the dial, each "click" is equivalent to a 2% change in intensity so it will
take 5 clicks to advance from one indicator LED to the next.