Introduction To The Reefbeat App; Preparations Before Installing - Red Sea ReefRun Dual Controller Benutzerhandbuch

Introduction to the ReefBeat app

All Red Sea's connected devices are operated via the ReefBeat app
which must be installed on a mobile device with an internet connection
(including tablets). See the full list of supported mobile devices on our
website.
Through your personal user account, ReefBeat enables you to set up and
manage any number of aquariums and add multiple devices to each of
them.
For full functionality, each RRDC must have a permanent connection
to the internet through your home Wi-Fi network. In this mode of
operation, you will be able to see the current status of your RRDC units,
change the settings or receive notifications on your mobile device
whenever you have access to the internet.
The ReefBeat homepage will show you the current status of all your
connected devices, and links you directly to the Settings page of each
unit.
You can install the ReefBeat on multiple mobile devices by entering the
same user account details. All mobile devices will have the same rights
for operating and changing all the settings. You should keep this in mind
before giving your user details to any 3rd party.
If you do not have a home network or your home network does not
have an active internet connection, you can connect and control your
RRDC units in Offline or Direct Mode. However, certain functionalities
such as remote access, multiple mobile devices or status notifications
will not be available.
ReefBeat is constantly under development. For the most up to date
operation instructions, view or download the latest user guide from the
Red Sea website at www.redseafish.com
If this is your first Red Sea connected device, it is recommended that
you complete the physical installation of your RRDC before installing the
ReefBeat app.
Preparations before installing the ReefRun Dual
Controller
Locate the RRDC controller in a convenient position and attach the
mounting bracket using the screws or adhesive tape provided. The
controller is designed to operate in a humid environment but it is not
waterproof. Please take the appropriate precautions in choosing its
location or when removing the controller from the mounting bracket.
Install one or two ReefRun compatible return DC-pumps or DC-Skimmers,
or one of each according to the installation instructions provided with
the product. Make sure that the pumps are in water before they are
switched on as the pumps enter a malfunction state if they identify that
they are running dry.
Connect the PSU-connector of the control-cable to the outlet cable of the
pump power supply.
Connect the pump-connector of the control-cable to the pump cable.
Connect the controller-connector of the control-cable to one of the pump
inlets ports on the controller.
If the optional RSK-sensor is to be used, connect it to the sensor port on
the controller.
Make sure that the inlet port covers remain on any of the connector
ports that are not being used.
When all preparations are complete, connect the AC cable of the power
supplies to the wall outlet. The pump status LED will turn on to show
that the pump power supply is connected, however, the pumps will not
work until the controller has been onboarded to the ReefBeat App and
the pumps have been set up.
Red Sea ReefRun ® Dual Controller
ENG
11