Prior Using For The First Time - BOMANN GSPE 7414 TI Bedienungsanleitung, Garantie

Haushalts- einbau-geschirrspüler

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

seated.

• Connect the other end of the inlet

hose to the inlet valve on the rear

of the appliance; also ensure that

it is firmly seated.

Connecting the water drain hose

NOTE:

The water drain hose is approx. 1.5 m long and can

be extended to max. 4 m with a suitable hose and

connector.

CAUTION:

To prevent dirty water from flowing back, the free end

of the hose must not be below the water level of the

drain.

• Connect the drain hose to a drainpipe (B) with a

minimum diameter of 40 mm; alternatively, the

hose can be attached to a sink or directly to the

drain (A).

• In any case, make sure that the drain hose is not

bent or squeezed.

• The drain hose may be installed up to a maximum

height of 1000 mm above the rinsing floor.

• Fasten the hose securely to prevent it from

changing its position and thus leaking water.

Electrical connection

WARNING:

• The installation to the mains supply must conform

to the local standards and regulations.

• Improper connection may cause to an electric

shock!

• Do not use multiple sockets or extension cords.

• It is not allowed to modify the plug provided with

the appliance! If the plug does not fit properly to

the outlet, let install a proper outlet by an author-

ized specialist.

• The accessibility of the power plug must always

be ensured to disconnect the appliance from the

power supply in case of an emergency.

• Make sure that the voltage supply matches the

specifications on the rating label (door frame) be-

fore connecting.

• Connect the mains cable to a properly installed

and earthed wall outlet.

• If the plug after installation is not accessible, a

corresponding disconnect device must be availa-

ble to meet the relevant safety regulations.