Prior Using For The First Time - BOMANN GSPE 7416 VI Bedienungsanleitung, Garantie

• Connect the drain hose to a drainpipe (B) with a
minimum diameter of 40 mm; alternatively, the
hose can be attached to a sink or directly to the
drain (A).
• In any case, make sure that the drain hose is not
bent or squeezed.
• The drain hose may be installed up to a maximum
height of 1000 mm above the rinsing floor.
• Fasten the hose securely to prevent it from
changing its position and thus leaking water.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not use multiple sockets or extension cords.
• It is not allowed to modify the plug provided with
the appliance! If the plug does not fit properly to
the outlet, let install a proper outlet by an author-
ized specialist.
• The accessibility of the power plug must always
be ensured to disconnect the appliance from the
power supply in case of an emergency.
• Make sure that the voltage supply matches the
specifications on the rating label (door frame) be-
fore connecting.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Prior using for the first time

Before using your dishwasher for the first time:
A. Filling salt into the salt container (water softener)
B. Filling the rinse aid dispenser
C. Filling detergent
CAUTION:
• Use only salt, rinse aid and detergent for dish-
washers. Other products may damage the appli-
ance.
• Always consider the dosage and storage recom-
mendations on the sales packaging.
WARNING:
Keep salt, rinse aid and detergent out of reach of
children.
A. Filling salt into the salt container (water softener)
Water softener
Water hardness varies regionally. If hard water is
used in the dishwasher, deposits form on the dishes
and kitchen utensils. The appliance is equipped with
a water softener, that removes lime and minerals
from the water by using water softening in the salt
container. Your local water authority can advise you
on the hardness of the water in your area.
Adjusting the salt consumption
The salt consumption can be adjusted according to
your water hardness and thus be regulated optimally.
• Switch on the appliance.
• Press the program selection button for more than
5 seconds, the setting mode is now activated for
approx. 60 seconds.
• By repeatedly pressing the program selection
button the water hardness can be selected:
32