Prior Using For The First Time - BOMANN GSP 7408 Bedienungsanleitung, Garantie

• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Prior using for the first time

Before using your dishwasher for the first time:
A. Filling salt into the salt container (water softener)
B. Filling the rinse aid dispenser
C. Filling detergent
CAUTION:
• Use only salt, rinse aid and detergent for dish-
washers. Other products may damage the appli-
ance.
• Always consider the dosage and storage recom-
mendations on the sales packaging.
WARNING:
Keep salt, rinse aid and detergent out of reach of
children.
Water hardness
°dH Mmol/l
0 – 5 0 – 0.94
6 – 11 1.0 – 2.0
12 – 17 2.1 – 3.0
18 – 22 3.1 – 4.0
23 – 34 4.1 – 6.0
35 – 55 6.1 – 9.8
°dH: German degree of hardness
Every cycle with a regeneration operation consumes additional 2.0 liters of water, the energy consumption
1)
increases by 0.02 kWh and the program extends by 4 minutes.
Setting
H1
H2
H3
(factory setting)
H4
H5
H6
A. Filling salt into the salt container (water softener)
Water softener
Water hardness varies regionally. If hard water is
used in the dishwasher, deposits form on the dishes
and kitchen utensils. The appliance is equipped with
a water softener, that removes lime and minerals
from the water by using water softening in the salt
container. Your local water authority can advise you
on the hardness of the water in your area.
Adjusting the salt consumption
The salt consumption can be adjusted according to
your water hardness and thus be regulated optimally.
• Switch on the appliance.
• Press the program button for more than 5 sec-
onds, the setting mode is now activated for ap-
prox. 60 seconds.
• By repeatedly pressing the program button the
water hardness can be selected: H1->H2->H3
->H4->H5->H6. The display indicates the selec-
tion (see below table).
• The setting will be saved automatically after a few
seconds; alternatively, exit the setup via the pow-
er button.
Regeneration occurs every
X program sequence
No regeneration
10
5
3
2
1
29
Salt consumption / cycle
1)
0 g
9 g
12 g
20 g
30 g
60 g