BOMANN GSPE 7414 TI Bedienungsanleitung, Garantie Seite 30

Dimension and preparation of the decoration panel
Prepare the wooden decorative panel according to
the dimensional drawing below.
CAUTION:
Before drilling, check the furniture front for sufficient
thickness.
Unit mm
• Align the enclosed drilling template and mark the
necessary drill holes. Check them with a spirit
level.
• Drill holes of Ø 2 mm and approx. 8 mm depth at
the pre-marked positions in the panel.
Fixing the decoration panel
• Separate the supplied Velcro strips (A) and (B)
from each other.
• Stick the Velcro strip (A) on the wooden panel
(top and bottom) and the felt strip (B) to the appli-
ance door at the appropriate height.
• Align the panel and the appliance front with each
other and fix the panel to the appliance door.
• To do this, first remove the short screws (4xS1)
mounted at the factory from the inside of the door.
Screw in the supplied long screws (4xS2).
•
Using the spacer bar
With this accessory, you can compensate the gap
between the control panel and decoration panel.
The spacer bar consists of several layers, that are
connected with a click mechanism.
Adjust the height of the top spacer to the gap. To do
this, remove the appropriate number of layers.
Adjusting of the door spring tension
After fixing the decoration panel, the door spring
tension must be adjusted accordingly.
• Turn the set screws clockwise or counterclock-
wise as required. The steel cable tightens or loos-
ens.
• Check the door spring tension. If the appliance
door remains horizontal when fully open, but close
easily, the tension is set correctly. Otherwise,
make the adjustment again.
30