Product Identification; Product Overview; Main Menus - Emerson AVENTICS PE7 Montageanleitung

The product detects the pressure of media of fluid group 2 and shows the mea-
sured values on the display. Optionally, the product additionally outputs a switch
signal and / or an analog signal.
Due to its design, the product is suitable for use in the tightest of spaces. The
product is vacuum-proof.
All outputs (switch output / analog output / IO-Link) are fully configurable. The
display and a virtual, two-part scroll wheel allow extended display and diagnostic
options. Menu items are displayed in plain text with color highlighting.
5.2 Labeling and identification
CE mark and UKCA identification
This product complies with the Electromagnetic Compatibility (EMC) Di-
rective 2014/30/EU and its amendments. The product is labeled with CE
and UKCA identification. The declaration of conformity is available on re-
quest.
Please provide the material number and serial number for the correspond-
ing products.

Product identification

The ordered product is clearly identified by the material number. The material
number can be found in these locations:
• On the name plate.

5.3 Product overview

6
5
4
Fig. 1: Product overview
1 TFT touch display 160x80 px
3 350° rotatable housing
5 Process connection
5.3.1 Operating functions and operating elements

Main menus

Main menu Display
1
2
3
4
AVENTICS™ PE7 | R412028734-BAL-001-AA | English
1
3
2 Electrical connection
4 M5 internal thread for pressure peak
throttle
6 Wrench flats process connection
Meaning
Energy saving mode: Display
OFF (in 30 s)
Pressure value display
Pressure value display with
5.00 5.50
details of Out 1 / Out 2
0-25
Settings
Structure of the status display
1 Output 1
3 Switching point S at displayed value
5 currently measured pressure
7 Range Lo at displayed value (analog
start point)
9 Output 2
Navigation using swipe gestures
Fig. 2: Touch display
1 Touch area
2
Fig. 3: Navigation through the menu
Direction
Top / bottom
Left
Right
Scroll wheels
The scroll wheels can be used to set numerical values. The scroll wheels are al-
ways divided after the first two digits from the right. In the default setting with
the "bar" pressure value, the division of the scroll wheels corresponds to the deci-
mal place. With other units or display settings, the division may differ.
Left scroll wheel
Both scroll wheels can be operated independently of each other.
Function
Adjust value by 1 digit
Start scroll wheel cycle
1 2 3 4
5.00 5.50
10
0-25
9 8 7 6
2 Hysteresis mode
4 Resetting point R at displayed value
6 Range Hi at displayed value (analog
end point)
8 Analog output 4-20 mA
10 Screen lock status
2 Display area
Function
• Switch between main menus
• Scroll
• Switch to submenu or confirm selection
• Switch back to main menu from last sub-
menu
• Switch to Easy Mode
• Switch back to a higher-level menu
Right scroll wheel
Operation
Swipe 1x up or down
Swipe up or down 2x, within 0.5 s
5
1
2
13