To Install/Remove The Abrasive Belt - 3M 33573 Bedienungsanleitung Und Sicherheitshinweise

All manuals and user guides at all-guides.com

TO INSTALL/REMOVE THE ABRASIVE BELT

1 . Disconnect the tool from the air line .
2 . Hold the tool with the contact arm pointing downward . Push the contact arm against a hard surface to gain some slack until the
safety latch (A) clicks into the locking position .
3 . Unfasten the set screw (B) . (See Fig . 1)
B
A
(Fig. 1)
4 . Rotate the belt cover (C) and replace the belt . （ See Fig . 2)
C
(Fig. 2)
5 . Press the safety latch (A) until the contact arm springs back to its original extended position . (See Fig . 3) .
6 . Rotate the belt cover into the closed position and tighten the set screw (B) .
C
B
A
(Fig. 3)
10 Translation of Original Instructions