Light Signals (Status Signals And Error Messages) - Assa Abloy KESO Integra Installations- Und Montageanleitung

Signal
gr 0.5 s (1x) gr 0.25 s (4x)
gr 0.5 s (1x)
gr 0.5 s (1x) gr 0.25 s (1x) ye 0.25 s (2x)
gr 0.25 s (1x 10 seconds each)
gr 0.5 s (1x) rd 0.25 s (4x)
rd 0.5 s (1x) rd 0.25 s (4x)
gr 0.25 s (1x 10 seconds each)
ye 0.25 s (1x 5 seconds each)
rd 0.25 s (1x 5 seconds each)
rd 0.25 s (1x)
rd 0.25 s (2x)
Tab. 1 : Status messages and error messages
gr green ye
Functions and operation

Light signals (status signals and error messages)

The external knob is equipped with a plastic cap with light function for signalling
status and error messages (Tab. 1).
yellow rd
Description
Authorised ID medium identified, the door can be
opened.
Unauthorised ID medium read, the door cannot be
opened.
Authorised ID medium identified, office function
switched on or off by conscious action.
Office function is active.
Authorised ID medium identified, real-time clock
not OK, time deviation very probable.
Unauthorised ID medium identified, real-time clock
not OK, time deviation very probable.
Authorised ID medium identified, real-time clock
OK, battery weak.
Battery is heavily used (approx. 2 %), battery ex-
change required.
Battery is empty (approx. 1 %), battery exchange
required.
· Lockboard initialisation not possible (if lockboard
is missing or incorrect),
restart (power reset) required.
· Motor cannot be closed due to mechanical fault
(with door handle pressed down), door handle
must be brought into horizontal position.
UHF device not in power safe mode,
Restart (power reset) required.
red
43
EN