Sagola PSAM104 Gebrauchsanleitung Seite 33

32/33
Difuser
The gun difuser interrupts the jet and reduces the risk of injection when the cap is not in place. To
check the operation of the difuser, follow the decompression procedure and then remove the tip.
Adjust the pump pressure to the lowest setting. Aim the gun toward a metal bucket which is
properly grounded. Remove the gun safety catch and press the trigger. The jet should be unstable
and swirling. If the jet is even, replace the difuser immediately.
Tip protector
ALWAYS keep the tip protector in its place on the gun whilst spraying. The protector gives warning
of the risk of products being injected onto the skin and assists in reducing this danger, but it does
not eliminate the risk of fingers or any part of the body from being placed too near the spraying tip.
Trigger protector
ALWAYS keep the trigger protector in place on the spray gun while this is in use in order to reduce
the risk of accidental operation of the gun if it is dropped or knocked.
Spray tip safety systems
Every precaution must be taken during cleaning or replacing spray tips. If the spray tip becomes
clogged when spraying, inmediately place the trigger lock. ALWAYS follow the descompression
procedure and then remove the spray tip to clean it.
NEVER remove the product remaining on or around the spray tip until
the pressure has been eliminated and the safety catch is in place.
14.2. Hose safety
The product circulating at high pressure in the hoses is potentially very dangerous. In the event
of a leak or burst in the hose due to wear of any kind, damage or improper use, the high pressure
jet issuing from the hose may cause the product to be injected or any other severe body injury as
well as damage to materials.
ALL PRODUCT HOSES MUST BE FITTED WITH PROTECTION SPRINGS AT BOTH ENDS. Protection
springs help to avoid the hoses from becoming constricted or twisting near the join, which would
cause them to burst.
ADJUST as tightly as possible all connections through which product will circulate. Products under
high pressure can disengage loose connections or allow the product to issue from the loose
connection under pressure.
NEVER use a damaged hose. Before each use, check the entire length of the hose for leaks,
scrapes, raised portions on the outer coating, damage or loose connections. If any of these are
detected, replace the hose immediately. DO NOT attempt to use the high pressure hose or repair
it with adhesive tape or any other element.
HANDLE AND ARRANGE THE HOSES WITH CARE. Do not pull the hose to move the equipment.
Keep the hose away from moving parts and surfaces of the pump and motor which may be hot. Do
not use products or solvents which are incompatible with the inner finish or outer coating of the
hose. DO NOT EXPOSE Sagola hoses to temperatures in excess of 82°C or below -40
Electrical continuity of the hose
The maintenance of adequate electrical continuity in the hose is essential to ensure the
uninterrupted grounding of the spraying system. Check the electrical resistance of your product
hoses at least once a week. Use a resistance gauge of suitable characteristics for your hose for
measuring the resistance. If the resistance should exceed the recommended limits, replace it
immediately. A hose which is not grounded or is incorrectly fitted may cause the system to be
dangerous. See also RISK OF FIRE OR EXPLOSION.
ENGLISH
o C.