Clock Setting - auna Patagonia DAB+ Bedienungsanleitung

EN
30
Low battery indicator
When using battery power to operate this unit and the battery power
becomes weak, the low battery icon will appear & flashing on LCD display.
You are recommended to charge the rechargeable battery.
Power button
Press and hold the power button  to go to the standby mode.
•
Press Power button again to turn on the unit.
•
Standby mode: Press and hold the power button  3 seconds to power
•
off.

CLOCK SETTING

When the unit is in standby mode:
1. Press the CLOCK button, the day digits will flash on the display.
2. Press the TUNING (∧/∨) button repeatedly to adjust the day digits, then
press the SELECT button to confirm. The month digits will flash on the
display.
3. Press the TUNING (∧/∨) button repeatedly buttons to adjust the month
digits, then press the SELECT Button to confirm. The year digits will
flash on the display.
4. Press the TUNING (∧/∨) button repeatedly to adjust the year digits,
then press the SELECT Button to confirm. The hour digits will flash on
the display.
5. Press the TUNING (∧/∨) button repeatedly to adjust the hour digits,
then press the SELECT button to confirm. The minute digits will flash on
the display.
6. Press the TUNING (∧/∨) button repeatedly to adjust the minute digits,
and then press the SELECT button to confirm.
The time is now set
Note: If the unit was reset or if you are charging a completely dead battery,
you need to set the clock again.