Specifications; Characteristic Curves - Kärcher BP 3.200 Home Originalbetriebsanleitung

Fault
The motor restarts imme-
diately after switching off
The pump capacity drops
or is too low
Vibrating noise during
water removal
Mains voltage
Power frequency
Nominal power
Device performance data
Maximum flow rate
Suction height (max.)
Pressure (max.)
Max. pressure of the air filling in the storage tank
Max. permissible inner pressure in the storage tank
Delivery height (max.)
Dimensions and weights
Weight (without accessories)
Note
Reason for exception according to regulation (EU)
2019/1781 Annex I Section 2 (12): (j)
Subject to technical modifications!
Cause
The pressure in the system is lost.
The air pressure in the storage tank is too
low.
The return valve does not close properly. 1. Check the check valve on the suction side.
The membrane in the pressure tank is
defective.
The suction filter or the check valve (spe-
cial accessory) are contaminated.
The delivery rate of the pump depends
on the delivery head and the connected
periphery.
The membrane in the pressure tank vi-
brates.

Specifications

Rectification
1. Check the connections including seals and
check for water leakage. The slightest
leakage affects operation.
1. Fill the storage tank with 2.0 bar (see chap-
ter Care and maintenance).
1. Have the membrane replaced.
1. Clean the suction filter or the check valve
(special accessory).
1. Observe the max. delivery head (see chap-
ter Specifications) Select a different hose
diameter or a different hose length if nec-
essary.
1. An operating noise that can be eliminated
by reducing the pressure of the air filling in
the storage tank.
BP 3.200 Home
V 230-240
Hz 50
W 600
l/h 3200
m 8
MPa (bar) 3,6
MPa (bar) 0.18 - 0.2 (1.8 - 2.0)
MPa (bar) 0.50 (5.0)
m 28
kg 10,5

Characteristic curves

English
BP 4.900 Home
230-240
50
1150
4900
8
5,0
0.18 - 0.2 (1.8 - 2.0)
0.50 (5.0)
35
13,9
11