Accessories Connections; Connections Photocell & Signal Light (Sl Only Available In The Sl Set); Coding In A Remote Control - Schartec P190 Anleitung

2.2 Accessories connections

Connections photocell & signal light (SL only available in the SL set)

1 2 3 4
Lit+ Lit- Lat+ Lat- M1+ M1-
Signal light with
24 V AC/DC
connection
 Connections for push-button / key-switch / electric lock (not included)
1 2 3 4
Lit+ Lit- Lat+ Lat- M1+
Electric Lock
AC/DC
Connection
NOTE: Operating options can be changed under the menu
settings"FK/FL" (see p. 30).
WARNING: The electric lock must be mounted on the gate
which opens first and closes last!

2.3 Coding in a Remote Control

Press "RF-learn" button for 2 seconds, the blue LED will come on; then press the upper left button on the
remote: the blue LED will blink three times and then turn off after 10 seconds. The remote is now coded in.
RF-Learn
Blue LED ON
2 Sec
NOTE: Erase transmitter Memory (on motherboard): Press and hold the "RF-LEARN"
until blue LED goes out.
5 6 7 8 9 10 11 12 13 14 15 16 17 18
M2+ M2- 5V 5V S1 S2 GND Lmt1 Lmt2 GND Lmt3 Lmt4 Gnd
5 6 7 8 9 10 11
M1- M2+ M2-
5V S1 S2
+
12-24V AC/DC
12 13 14 15 16 17 18
GND Lmt1 Lmt2 GND Lmt3 Lmt4 GND
Connection for
dual gate
operation
Blue LED blinks three times
25
19 20 21 22 23 24 25 26
DKey SKey GND Ph1 PhVcc GND Ph2 PhVcc
-
NO NC
COM
Receiver
Photocell
19 20 21 22 23 24 25
DKey SKey GND Ph1 PhVcc GND Ph2 PhVcc
Connection for
single gate
operation
button on the circuit board for 10 seconds
-
+
12-24V AC/DC
Sender
26
Blue LED OFF