Schartec P190 Anleitung Seite 21

Performance
For the duration of the warranty, we shall resolve any defects of the product which are demonstrably attributable to a
material or manufacturing defect. At our discretion, we shall, free of charge, replace the defective product for a non-
defective, repair or refund a diminished value. Excluded are damages caused by:
Improper installation and connection
•
Improper commissioning and operation
•
External influences such as fire, water, abnormal weather conditions
•
• Mechanical damage due to accidents, dropping or shock
• Negligent or deliberate destruction
Normal wear and tear or poor maintenance
•
Repair by unqualified persons
•
• Use of non-original parts
• Removal or obscuring of the serial number
Replaced parts become property of the manufacturer
•
IMPORTANT! In the event of failure of the operator, a specialist must be directly commissioned for inspection and/or repair
of the operator / gate.
3. Checking the Gates / Gate system
The operator is not designed for the operation of heavy gates, i.e. gates which cannot be opened or closed with
minimal difficulty by hand. It is therefore absolutely necessary to check the gate before installing the operator and
make sure that it can be easily moved by hand and that the gate system is safe. Also, inspect the entire gate system
(joints, hinges, bearings, and mounting parts) for wear and / or possible damage. Check whether rust, corrosion or
cracks are present. The gate system must not be used if repairs, adjustments or maintenance work is required. An
error in the gate system or an improperly adjusted gate can also lead to serious injuries.
IMPORTANT! Before installing the operator, make sure that any necessary repairs or adjustment / maintenance work
are carried out by a qualified person.
4. Important Instructions for Safe Installation
The installer of the operator must ensure that all national and European regulations for the operation of electrical
equipment are complied with.
5. Before the Installation
All mechanical locking devices of the door, which are not required for actuation with a swing gate opener, must be
disassembled before installation of the operator. These include, in particular, locking mechanisms connected with the
door.
6. When performing Installation
When carrying out the assembly and installation of the operator, the applicable safety regulations must be observed.
IMPORTANT! When drilling, the operator must be protected and covered so as to avoid later malfunction from drilling
dust or drilling chips.
7. After completion of Installation
Once the assembly has been completed, the installer must account for conformity to DIN EN 13241-1.
8. Warning notice
Ensure that permanently installed control devices (such as push buttons) are placed within sight of the gate but away
from moving parts and at a minimum height of 1.50 m. Keep out of reach of children.
Ensure that there are no persons or objects in the movement area of the door/gate. Ensure that children do not play
on or with the gate.
Make sure that the included warning signs are placed prominently on the door/gate.
21