Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONNECTIONS
DMX512 control
DMX Controller
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1
Connect the output of your DMX controller to the DMX input DMX IN of the device with a DMX cable.
2
Connect the DMX output DMX OUT of the device to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3
At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4
If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
XLR connection:
Wireless DMX transmission with QuickDMX
T The device features an alternative DMX input for a QuickDMX receiver (sold separately). CRMX and
WDMX receivers are compatible and can also be used. The connector allows a DMX control signal to be
transmitted wirelessly to the device, eliminating the need for complex wiring to the DMX controller. The
connector is designed as a USB port which provides the required 5 V operating voltage for the receiver.
Occupation of the USB port:
Device 1
Start Address 1
DMX OUT
SAFETY
ROPE
Program
DMX IN
Chase32 Step100
Device 2
Start Address 24
DMX OUT
SAFETY
ROPE
IR
DMX IN
24/36
Device 3
Start Address 47
DMX OUT
SAFETY
ROPE
IR
DMX IN
00143647, Version 1.1
IR
Werbung
Inhaltsverzeichnis
