THERMODYNE UTILLIAN 8 Bedienungsanleitung Seite 25

Cleaning - Glass Mouthpiece
For cleaning the Glass Mouthpiece, remove it from the Base. You can submerge the
Glass Mouthpiece into isopropyl alcohol and leave it submerged so the grime can
dissolve. After some time, you can remove it from isopropyl alcohol and rinse clean
with water. Allow the Glass Mouthpiece to thoroughly dry before you re-attach it
to the Base.
Do not allow water or water-based cleaning agents into the Base at any time.
Cleaning - Base
Prior to cleaning the Base remove the Multi-Tool, Carb-Cap Base, BurstHit 3D
Heating Chamber™ and the Glass Mouthpiece.
You can remove the Vapor Path between the BurstHit 3D Heating Chamber™ and
the Glass Mouthpiece by pushing down the end of the Vapor Path, which is adjacent
to BurstHit 3D Heating Chamber™. Through this push, the end of the Vapor Path
close to the Glass Mouthpiece lifts up and can now be easily pulled out.
Operation of the Device EN
EN EN
25 25