THERMODYNE UTILLIAN 8 Bedienungsanleitung Seite 15

Heat Cycle
Pushing and holding the Power Button
for 2 seconds will engage the heat cycle,
which is being shown through visual
and haptic cues. The LEDs of the Status
Interface will get illuminated one by one
until the heat cycle is engaged. Also, the
2 s
device vibrates after 2 seconds.
Heat-up can always be aborted, by
pushing and holding the Power Button
for 2 seconds. The device will then
vibrate and the LEDs will turn off.
The heat-up is indicated by pulsing red LEDs. The device heats according to the
last chosen temperature level. The 4 temperature levels can be recognized by the
differing number of the LEDs of the Status Interface:
EN
EN Operation of the Device 15