Dmx-Mode - EuroLite LED PIX-12 HCL Bar Bedienungsanleitung

Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.

DMX-MODE

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 74 control channels.
However, it can also be switched to a mode with 4, 6, 16 or 36 channels if different functions are required. To
be able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until Addr is indicated on the display. Confirm with the ENTER
button.
2 The display indicates 4 CH (4 DMX channels), 6 CH (6 DMX channels), 16 CH (16 DMX channels), 36
CH (36 DMX channels) or 74 CH (74 DMX channels). Use the buttons UP and DOWN to select the
desired number of DMX channels. Confirm with the ENTER button.
3 Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
4 When DMX control signals are received, a dot flashes in the display. If the control signals are missing,
the dot does not flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed to the
same address, they will work synchronically.
Controlling
After having addressed the LED PIX-12 HCL Bar, you may now start operating it via your lighting controller.
The LEDs of the device are separated into 12 pixels on the main panel, which can be individually controlled
with the following DMX-protocol.
The LEDs of the device are arranged as shown in the graphic below.
2
1
6
5
4
3
32/40
1 0
9
8
7
IR
1 2
1 1
00143097, Version 1.1