Care And Maintenance - Hilti Nuron VC 10L-22 Original Bedienungsanleitung

6.4 Vacuuming up liquids
CAUTION
Risk of injury by dusts that are hazardous to health! Hazardous material that has been vacuumed up can
escape if a filter element is not used.
▶ Use the vacuum cleaner only with a filter element installed.
When the appliance is used to vacuum up drilling slurry and solid materials, there is a possibility of
the filter element being damaged. Take note of changes in suction power when vacuuming up these
substances.
1. Check the container level monitoring system. → page 36
2. If possible, use a separate filter element for wet applications.
6.5 After vacuuming up liquids
1. Open the 2 latches.
2. Lift the suction head off the waste material container and place the suction head on a level surface.
▶ Allow the filter element to dry.
3. Empty the waste material container and use a water hose to wash out the waste material container.
4. Check the container level monitoring system. → page 36
5. Clean the dry filter element by wiping it with your hand.
6. Check the filter element for damage.
▶ Replace a damaged filter element.
6.6 After use of the vacuum cleaner
1. Turn the control switch to the OFF position.
2. Empty the container and clean the vacuum cleaner with a damp cloth.
3. Store the vacuum cleaner in a secure, dry place where it is inaccessible to unauthorized users.
▶ CAUTION This vacuum cleaner may be stored only indoors.
7

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Li­ion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
• Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
34 English 2330315
*2330315*