Troubleshooting - BOMANN GSP 7408 Bedienungsanleitung, Garantie

Clean the spray arms under running water; if
•
necessary, use a soft cleaning brush for the noz-
zles.
Replace the spray arms until they audibly click
•
into place. Tighten the nut of the upper spray
arm.
Care of the dishwasher
CAUTION:
Do not use spray cleaners to clean the door panel,
as they may damage the door latch and electrical
components.
• Carefully clean the exterior surfaces of the appli-
ance and the rubber door seal with a soft, damp
cloth. Only use mild cleaning agents.
• To remove stains inside the appliance, use a cloth
moistened with a little vinegar or a special clean-
ing agent for dishwashers. If necessary, add de-
tergent and start the appliance without dishes in
the program with the highest temperature.
• Thoroughly dry the outer surfaces of the appli-
ance before putting it back into operation.
Antifreeze protection
If the appliance is out of service and exposed to tem-
peratures below zero, contrary to our recommenda-
tion, observe the following measures:
• Disconnect the appliance from the power supply.
• Close the water supply and remove the inlet hose
from the water valve.
• Drain the water from the inlet hose and the water
valve.
• Remove the lid of the salt container and take out
the filter system. Remove the remaining water in
the sump with an absorbent sponge.

Troubleshooting

Before contacting authorized specialist
Malfunction / cause / action
Appliance does not start
- Check the power supply.
- Is the appliance switched on?
- Is a program selected?
- Is the water supply connected correctly, is the
water supply open?
Water is not drained off
- Check the drain hose.
- Are the filters or the kitchen drain blocked?
Noises
- Make sure all dishes are secured in the dish-
washer.
- Place items so that the spray arms can rotate
freely.
Foaming
Use only special dishwasher detergent to prevent
foaming. Should this occur, open the dishwasher
door and allow the foam to escape. If necessary,
add some cold water to the tub. Start a rinse cycle
to drain the water.
Plates, other flatware is not clean
- Select a stronger program.
- Make sure that the function of the spray arms is
not blocked by large dishes.
Stains and film formation
- Extremely hard water.
- Low inlet temperature.
- Overloading, incorrect loading.
- Old or damp detergent.
- Incorrect detergent dosage.
Staining of glassware
Use less detergent with soft water and select the
shortest rinse cycle to clean and rinse glassware.
38