Installation - BOMANN GSP 7408 Bedienungsanleitung, Garantie

Installation

WARNING:
The appliance must not be connected to the mains
during installing. Otherwise, there is danger to life or
electric shock hazard!
CAUTION:
• For proper operation, the appliance must be con-
nected professionally. The data of inlet and outlet
as well as the electrical connection values must
meet the required criteria.
• It is recommended that the installation, water
connection and electrical connection, be carried
out by a specialist.
Installation location
• The site should be located near the water inlet
and outlet, as well as near a properly grounded
power socket.
• Place the appliance so that all controls are easily
to reach, and the appliance door can open without
being impeded.
• Take care of a solid and horizontal position of the
appliance. If the appliance is not horizontally lev-
eled, adjust the feet accordingly (see
the feet"
).
• Power cord and water hoses may not kinked or
squashed.
• Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e. g. outdoors),
-
as metal parts would be susceptible to corro-
sion under such circumstances;
in rooms where the temperature could drop
-
below freezing. Do not expose the appliance
any weather.
near volatile or flammable materials (e. g. gas,
-
fuel, alcohol, paint, etc.).
Removing the appliance cover
The appliance cover can be removed and thus re-
ducing the unit height to 81.5 cm; to place the dish-
washer under a suitable kitchen worktop.
Adjusting the feet
Water connection
CAUTION:
• Installation to the water supply must be carried
out in accordance with local laws and regulations.
• The appliance is not suitable for hot water supply.
• Use the new hose set supplied to connect the
appliance to the water supply. Do not reuse old or
used connection sets.
"Adjusting
• If the water supply is new or has not been used
for a long time, make sure that the water is clear
and free of impurities before connecting it to the
water supply.
NOTE, the connection to the water mains may only
be made in accordance with DIN EN 1717 of the
drinking water ordinance. A suitable safety device
against drinking water contamination through back-
flow must be installed.
Notes on inlet hose safety system
(delivery scope depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
27
a) Loosen the screws on the unit
back and remove the cover.
b) After removing the cover, re-
tighten the screws.
Check with a spirit level whether
the appliance is leveled horizon-
tally. If the unit is not in balance,
the feet must be adjusted.