Cleaning And Maintenance - BOMANN GSP 7408 Bedienungsanleitung, Garantie

• Do not perform a pre-rinse cycle (depending on
the model) unless absolutely necessary.

Cleaning and maintenance

WARNING:
• Always switch off the appliance and disconnect it
from the power supply before cleaning and
maintenance work.
• Allow the appliance to cool down sufficiently be-
fore cleaning.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
• The appliance must be dry before you put it back
into operation.
CAUTION:
• Do not use a wire brush or other sharp, abrasive
objects.
• Do not use any acidic or abrasive detergents.
NOTE:
Dirty filters and clogged spray arms will affect rinsing
results. Check the filters and the spray arms regularly
and clean them if necessary.
Filter system
The three-part filter system pre-
vents large quantities of food
residues or foreign bodies from
entering the rinsing system.
1 Main filter: collected food and dirt particles are
pulverized by a special jet on the spray arm and
rinsed out via the water drain.
2 Coarse filter: filters larger objects such as pieces
of bone or broken glass that could block the drain.
3 Micro filter: filters dirt and food residues in the
sump area and prevents these contaminants from
settling back onto the dishes during the rinse cycle.
Cleaning the filter system
CAUTION:
• The dishwasher must never be operated without
filters.
• Improper insertion of the filters may affect the
performance and damage the appliance.
• Do not tap out the filters for cleaning to avoid
possible deformation of the filters.
NOTE:
After each rinse, check the filter for residues.
• Turn the coarse filter counterclockwise and re-
move the entire filter system upwards.
• Detach the coarse and the micro filters from the
main filter.
• Remove food residues and clean the filters under
running water. Use a soft cleaning brush if neces-
sary.
• Reassemble the filter system properly in reverse
order and in its intended position. Fix the entire
system by turning the filter unit clockwise.
Cleaning the spray arms
Lime and impurities from the rinsing water can block
nozzles and bearings of the spray arms. Check the
outlet nozzles of the spray arms regularly for block-
ages.
• Unscrew the fastening nut of
and pull the arm downwards.
Remove the lower arm upwards.
•
37
the upper spray arm