Option Settings; Automatic Closure; Force, Sensitivity, Speed; Adjustment Of Force - EasyWay 110 Benutzerhandbuch

6. OPTION SETTINGS

6.1 Automatic closure

Automatic closure is started after the previously set interval time.
The INTERVAL TIME can be set by pressing the "-"
and "+" buttons.
Wait for 20 seconds or press the CLOCK ICON
again in order to leave the programming mode.
Work cycle: OPEN - INTERVAL - CLOSE - INTERVAL

7. FORCE, SENSITIVITY, SPEED

7.1 Adjustment of force

Press the ADJUSTMENT ICON "1", the red LED
on the left will become lit:
Press "-" or "+" to adjust force.
a) Press the CLOCK ICON. The
green LED on the right will
become lit.
- If none of the LEDs between "-" and
"+" is lit, automatic closure is not active
– in order to activate it, it is necessary
to push the "+" button.
- If at least one "1" LED lights up,
automatic closure is activated – in order
to deactivate it, it is necessary to hold
the "-" button until all the LEDs go out.
LEDs ON INTERVAL TIME
Automatic starting is not active
5 s
10 s
30 s
60 s
120 s
40