Cabling And Connections - EasyWay 110 Benutzerhandbuch

In order to facilitate the procedure of making connections to the control panel and programming, it is
assumed that it needs to be removed from its seat.
This operation is simple and does not require any tools:
a) Pull the control unit up and, depending on what the cable lengths allow, place it on the edge of the base
of the automation housing or hold it in hand.
b) After the connection are made and/or the programming is finished, place the control unit back on its
support, simply pushing it gently until all the 4 hooks click.

3.1 Cabling and connections

- Prior to continuing making cabling and connections it is necessary to become thoroughly familiar with
SAFETY-RELATED RECOMMENDATIONS AND WARNINGS and RECOMMENDATIONS AND WARNINGS
REGARDING INSTALLATION.
- All the activities regarding cabling and connections need to be performed with the power supply source
disconnected.
32