Maintenance; General; Maintenance Schedule - Husqvarna DC 6000 Bedienungsanweisung

General

WARNING! The user must only carry out the maintenance and service work described in this
!
Operator's Manual. More extensive work must be carried out by an authorized service workshop.
The machine should be switched off with the power cable disconnected from the outlet.
Wear personal protective equipment. See instructions under the "Personal protective equipment"
heading. It is strongly advisable that all operators use a dust mask/respirator when changing dust
bags or performing maintenance on the machine.
The life span of the machine can be reduced and the risk of accidents can increase if machine maintenance is not carried
out correctly and if service and/or repairs are not carried out professionally. If you need further information please contact
your nearest service workshop.

Maintenance schedule

In the maintenance schedule you can see which parts of your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated based on daily use of the machine, and may differ depending
on the rate of usage.
Daily maintenance
Check that the cord and
extension cord are intact and in
good condition.
Clean the outside of the
machine.
Check the filter and if necessary
shake out the dust.
Never clean the filter with air
pressure or sharp objects as this
may damage the filter.
The user should carry out a daily
check on the amount of dust in
the filter housing.

MAINTENANCE

Weekly maintenance
Check the cyclone and
container
Check the rubber bellows
on the cyclone.
Make sure the grille on
the cyclone retainer is
clean.
Clean the compressor
filter. Replace if heavily
clogged.
Monthly maintenance
Clean the air dryer filter.
Replace if necessary.
Occasional maintenance
Wash the filter elements
with a gentle soft jet of
water.
English – 13