Merax MS194446 Bedienungsanleitung Seite 26

2) Safety key Introduction
The treadmill can only start when the safety key is put on the yellow area of the display console.
Clip the safety key on clothes when using the treadmill to avoid accidents. For emergency conditions,
remove the safety key can stop the treadmill immediately. And put the safety key back to continue
using the treadmill.
3) Folding Instructions
Fold the treadmill:
It will save space when the treadmill is folded.
Please turn off the switch and pull out the power plug before folding. Lift the running deck until
it is held.
Unfold the treadmill:
Kick the pressure rod, hold the running deck and then let the running deck to fall gradually.
4) Console instructions
Start-up: Press Start button to start the treadmill.
programs: 3 manual programs(mode), 12 automatic programs.
Safety lock function: Disconnect the safety key, "E7" shows on the screen. The treadmill stops
gradually, and a "beep" alarm sound is let out. Put the safety key back, all the data will be cleared in
2 seconds. Under any circumstance, the treadmill will stop when disconnect the safety key. There
will be prompt information on the screen. Put back the safety key, screen data will be back to the
initial interface.
5) Button function
Start button/Stop
When the power is on, press the start button and the screen will display "1.0 km/h", and the
treadmill will start. When you are running on the treadmill and press the stop button, all of the
data on the screen will clear and the treadmill will gradually come to a complete stop and
8
Kick here to
lower the
running deck.