Laser Control Module - Genmitsu CFL55P Benutzerhandbuch

Laser Control Module

The Laser Control Module matching the Laser Head contains the necessary control electronics for processing
the PWM signal applied to the input. This results in the laser being supplied with the required voltage at the right
time. The Laser Control Module can be mounted to the 2020 aluminum profiles normally used on milling and
engraving machines by means of the supplied T-nuts and M3 screws. A 2.5mm hexagon wrench is required for
mounting those screws.
06
The right side of the
Laser Control Module
hosts the connections
to the laser head. The
sockets are different
and match the plugs on
the Laser Head wires
so they can only be
connected correctly.
There is a Red Power
LED on the board close
to the connector
marked PWM, it is on
when power is supplied
to the Laser Control
Module.