Laser Module Installation - Genmitsu CFL55 Benutzerhandbuch

Laser Module Installation

STEP 1: Install the Lasr Module on Jinsoku LC-60A/LE-1620
1. Prepare your 4mm ID (7mm Outer Diameter)Air line tubing first. Connect one end of the tubing to the air
assist nozzle and the other end to the air pump. If you don't have an air pump or flexible tubing, you can
ignore this step.
2. Choose the correct laser module adapter plate according to your machines. Fix the laser module onto the
adapter plate with four M3*6 screws, and then install the plate on your machines with four M3 screws.
Choose the corresponding connection cable for your models, and connect it to the machine's controller.
3.
Note: We recommend removing the air assist nozzle when operating non-cutting jobs. To remove the nozzle,
you need to unplug the air tubing first and then loosen the screw fixing the nozzle, turn the nozzle counter-clockwise
to remove it.
Air
M3*6 Screw,
4PCS
Adapter Plate
Air Tubing
Air Nozzle
Outer Diameter Φ7.0
Fixing Screw
Inner Diameter Φ4.0
Vcc DC12V 2.5A
GND
PWM
(5V, 0~1KHz)
Laser Module
Plug
Air Nozzle Laser Shield
M3 Screw *4PCS
07