Genmitsu CFL55P Benutzerhandbuch Seite 11

Installation Guide for 3018-PRO & 3018-PROVer
STEP 2: Install the Laser Head
1. Raise the spindle holder to the top.
2. Push the laser module controller through the spindle holder.
3. Align the four corners of the laser module with the square slots, and then push the laser head into the spindle
holder.
4. Tighten the M4 screw when the top of the heat sink is aligned with the top of the spindle holder.
raise
Spindle Holder
push
Laser Module Controller
Spindle Holder Top
Spindle Holder Square Slots
Spindle Holder Square Slots
Heat Sink Top M4 Screw
push
09