Genmitsu CFL55P Benutzerhandbuch Seite 12

Installation Guide for 3018-PRO & 3018-PROVer
STEP 3: Install the Laser Module Controller
1. Slide an M3 T-nut into the aluminum profile.
2. Insert an M3*8 screw into the laser module controller and adjust the controller position，make sure the M3*8
screw and M3 T-nut is aligned then tighten the screw with two rotations.
3. Adjust the controller position again until the laser module controller is 5mm to the right of the machine
controller, then tighten it with an M3*8 screw.
Aluminum Profile
10
M3 T-nut M3*8 Screw Machine Controller Laser Module Controller