Husqvarna FS 305 Bedienungsanweisung Seite 11

To use the track widener
The track widener makes the product more stable.
1. Loosen the screw (A) for the track widener.
A
2. Pull the right rear wheel out until it stops.
3. Tighten the screw (A) for the track widener.
To install a cutting blade
1. Make sure that the engine ON/OFF switch is in its
OFF position.
2. Turn the cutting depth wheel clockwise to fully lift the
cutting blade. Push the lever to lock the cutting depth
wheel.
WARNING:
depth wheel when the cutting depth
wheel is not in use.
3. Stop the water supply and disconnect the water hose
from the blade guard.
1919 - 002 - 23.01.2023
Always lock the cutting
4. Lift the pointer (A) to an upright position.
A
C
5. Loosen the front nut (B) on the blade guard.
6. Lift the blade guard (C).
7. Remove the blade screw (D).
D
8. Remove the blade flange (E).
9. Examine the blade screw (D), the blade flange (E),
the inner flange (F) and the locking pin (G).
a) Clean all contact surfaces between the blade
and the blade flange. Clean the blade shaft bolt
threads and the contact surfaces of the blade
shaft bolt.
b) Replace worn or damaged parts.
WARNING:
can prevent correct installation of the
cutting blade.
F
E
Damaged or dirty parts
B
11