Produktbeschreibung; Für Alle Geräte; Untertischgeräte; Rozpakowywanie - Bosch TR4000 Montage- Und Gebrauchsanleitung

Installation instructions

2 Installation instructions
Install the continuous-flow heater as described in the
illustrated section. Observe the instructions in the text.
2.1

Unpacking

• Inspect the new appliance for transport damage!
• Please dispose of the packaging, and if applicable,
the old appliance in an environmentally-friendly manner.
Scope of delivery
(Fig. 1)
1. Housing
2. Mounting (3 screws, 3 wall plugs)
3. Operation indicator
(only on TR4000 6 EB and TR4000 8 EB)
4. Installation bracket
5. Mounting bracket
6. Aerator
7. Documentation
2.2

Product description

The electronic continuous-flow heater is suitable for closed
(pressurised) connections. It heats the water as it passes
through the appliance.
The continuous-flow heater switches on and heats the water
when the warm water tap is opened. It switches off as soon
as the tap is closed.
The appliance may not be operated with pre-heated water,
as otherwise the overtemperature protection will trip.
This installation and operating instruction manual describes
various appliance types:
Over-sink appliances:
• TR4000 6 EB and TR4000 8 EB:
for fixed electrical connection

Undersink appliances:

• TR4000 4 ET and TR4000R 4 ET: with plug connection
• TR4000 5 ET, TR4000 6 ET and TR4000 8 ET:
for fixed electrical connection
Only for permanently installed appliances:
The device is compliant to IEC 61000-3-12.
Preparations for installation
(Fig. 2)
• Shut off the water supply before connecting the
appliance. The electrical connection must be
disconnected from the mains supply. Unscrew the fuse
or switch off the circuit breaker.
16
2.3

For all appliances

A clearance of about 60 mm on all sides of the appliance
is required for installation.
• Observe the technical appliance data.
• Break out the installation bracket from the rear of the
appliance (A).
2.4 Only for TR4000 4 ET and TR4000R 4 ET
• Break out one of the side knock-outs (B1) provided for an
incoming electrical supply cable.
• Feed the desired length of the incoming electrical supply
cable downwards through the knock-out (B2).
• Important: Connect the unit only to a mains socket with
protective contact that is installed according to regulations.
Do not use an extension cord. If necessary, equip the unit
with a longer cord.
2.5 Only for TR4000 5 ET, TR4000 6 ET, TR4000 6
EB, TR4000 8 ET and TR4000 8 EB (fixed
electrical connection)
• Press the upper and lower latches (C1), then remove
the housing cover (C2).
Wall mounting
(Fig. 3)
2.6 Undersink appliances
• Attach mounting template D to the wall.
• Mark the locations for the holes; drill the holes and insert
the wall plugs.
• Attach the installation bracket to the wall using the
screws (D1).
Only for permanently installed appliances:
• Pass the connection cable through the cable grommet,
suspend the appliance in the installation bracket and screw
it onto the mounting bracket (D2).
Only for appliances with mains plug:
• Suspend the appliance in the installation bracket and screw
it onto the mounting bracket (D3).
TR4000 | TR4000R – 6720876021 (2022/04)