Manual Code Search; Automatic Search - Medion MD 81035 Anleitung

Manual code search

Carry out a manual search as follows:
1. Switch the relevant device on manually.
2. Keep the SETUP key pressed down for approx. 3
seconds, the background lighting of the source key will
flash for a short time and then remain permanently lit.
3. Briefly press the desired source key (TV, VCR, DVD,
ASAT, DSAT, CBL, CD, AUX).
4. Keep pressing the (up to 350 times) POWER; P+ or P–
or (VCR only) key until the device that is to be con
trolled switches off, changes channels, or responds
accordingly.
The code search begins at the currently stored three
digit number.
5. Briefly press OK to save the code.
Due to the considerable quantity of different code
numbers, up to 350 different codes are pre program
med per device type. In individual cases it may be
possible that only the most common main functions
are available. For some particular device models, the
described method may not lead to success.

Automatic search

If your device does not respond to the remote control even
though you have tried all of the codes listed for your device
type and the relevant brand, then try using the automatic se
arch. This will enable you to find codes for brands that were
not listed in the device Code List.
1. Switch the relevant device on manually.
2. Keep the SETUP key pressed down for approx. 3
seconds, the background lighting of the source key will
flash for a short time and then remain permanently lit.
3. Briefly press the desired source key (TV, VCR, DVD,
ASAT, DSAT, CBL, CD, AUX).
4. Point the remote control at the device and briefly press
the P+ key once.
If the device does not have a program function, then
instead of pressing P+ press
The remote control will begin the code search after 6
seconds and will transmit all codes consecutively at
one second intervals (see also the next section). The
source key will light up for each transmission.
5. As soon as the device responds to the remote control,
press OK. – If you missed pressing OK in time, you can
go back in steps to the code whichwhich the device
responded by using the P– key.
To cancel the search, press EXIT.
1 second or 3 second intervals
If you want the remote control to transmit a new code every
3 seconds instead of every second, proceed as follows:
Within 6 seconds of pressing the P+ key (or
WER) as described in Point 4, press the P+ or P– key
again. The remote control will now only transmit a new code
every 3 seconds. This gives you more time, but the proce
dure will also take longer.
or POWER.
5
UK
or PO-