ABB ACS880-14 Schnellinstalationsanleitung Seite 21

58.15 Communication 58.25 Control profile
loss mode
58.16 Communication 58.26 EFB ref1 type
loss time
Warnings and faults
￭
Warning Fault Aux. code
A2A1 2281 Current calibration
- 2310 Overcurrent
A2B3 2330 Earth leakage
A2B4 2340 Short circuit
- 3130 Input phase loss
- 3181 Wiring or earth fault
A3A1 3210 DC link overvoltage
A3A2 3220 DC link under-
voltage
- 3381 Output phase loss
- 5090 STO hardware fail-
ure
A5A0 5091 Safe torque off
A7CE 6681 EFB comm loss
A7C1 7510 FBA A communica-
tion
ACAB - Extension I/O con-
figuration failure
AFF6 - Identification run
- FA81 Safe torque off 1
loss
- FA82 afe torque off 2 loss
EN – Quick installation and start-up guide 21
58.31 EFB act1 transpar-
ent source
58.33 Addressing mode
Description
Warning: Current calibration is done at the next start.
Fault: Output phase current measurement fault.
The output current is more than the internal limit. This can
also be caused by an earth fault or phase loss.
A load unbalance that is typically caused by an earth fault in
the motor or the motor cable.
There is a short-circuit in the motor or the motor cable.
The intermediate DC circuit voltage oscillates due to missing
input power line phase.
Incorrect input and motor cable connection.
Intermediate DC circuit voltage is too high.
Intermediate DC circuit voltage is too low.
All three phases are not connected to the motor.
STO hardware diagnostics has detected hardware failure.
Contact ABB.
The Safe torque off (STO) function is active.
Break in embedded fieldbus communication.
Communication lost between drive (or PLC) and fieldbus ad-
apter.
The I/O extension module types and locations specified by
parameters do not match the detected configuration.
The motor ID run occurs at the next start.
The Safe torque off circuit 1 is broken.
The Safe torque off circuit 2 is broken.
58.101 Data I/O 1
...
58.124 Data I/O 24 time
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
SV
TR
ZH