Maintenance - Makita 9227CB Betriebsanleitung

FOR USE AS A SANDER
Installing or removing abrasive disc
(Fig. 1, 9 & 10)
Important:
Always be sure that the tool is switched off and
unplugged before installing or removing the abrasive
disc.
Mount the rubber pad onto the spindle. Fit the abra-
sive disc on over the rubber pad and screw the lock
nut onto the spindle. Press the shaft lock and tighten
the lock nut using the lock nut wrench. To remove the
abrasive disc, follow the installation procedure in
reverse.
NOTE:
The rubber pad, abrasive disc, lock nut and lock nut
wrench are optional accessories.
Sanding operation (Fig. 11)
CAUTION:
Always wear safety glasses or a face shield during
operation.
Keep the abrasive disc at an angle of about 15° to the
workpiece surface.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacement of carbon brushes (Fig. 12 & 13)
Replace carbon brushes when they are worn down to
the limit mark. Both identical carbon brushes should
be replaced at the same time.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
7