Passion Spas Renew Anleitung Seite 9

You can fix the filter by turning it clockwise.
.
• Switch on the electricity of the spa. Do not do this before the bath is
filled up to 'Water Level', which is indicated on the skimmer.
• The pump starts in basic mode and blows all the air out of the system.
It is possible that there is an air bubble inside the system. You will
notice this because all, or a few, jets are not streaming properly. Let
some of the water flow out of the drain if this is the case.
• Your dealer gave you a starters' maintenance kit, with which you can treat the water in
your spa for use. Follow the instructions carefully, use a first dose and continue to set
the control system.
• Follow the information in the control panel manual, depending on the type of
control system that you have. See Chapter 4.
• Turn off the air controls (see photo, open counter clockwise) after
you have set the control system to your satisfaction and place the
cover onto your spa so that it can be warmed up to the utmost.
Your spa is now being warmed up and filtered.
Note: The time that it takes for the spa to warm up will be longer and the heating costs will be
higher if you do not switch off the Air Controls or use the cover.
Airlocks
If you have emptied and refilled your spa and the pump comes on but there is no water movement in
your spa, the spa is probably suffering from an air lock. To get the air out of your pump, turn the spa
off and find the filtration pump, which is situated inside the spa cabinet. Locate the pipe which goes
into the top of the pump. This has a large nut, which is called the barrel union. Undo anti-clockwise
until you hear the air escape. When the water comes out, re-tighten. This should fix the airlock.
Sometimes you have to start the pump again to remove the air. To prevent this from happening,
always fill the spa through the filter box.
Air Control
9