Passion Spas Renew Anleitung Seite 11

Sleep Mode heats the spa to within 20°F/10°C of the set temperature only during filter cycles. will
display when water temp is not current, and will alternate with current water temp when the pump is
running.
Preset Filter Cycles
The first preset filter cycle starts at 8:00 AM and ends at 10:00 AM. The second preset filter cycle
starts at 8:00 PM and ends at 10:00 PM.
For non-circ systems, low-speed pump 1 and the ozone generator (if installed) run during filtration.
For 24 hour circulation systems, the circ pump and the ozone generator (if installed) run 24 hours.
In hot environments, the circ pump may turn off for 30 minute periods, except during filter cycles.
For non-24 hour circulation systems, the circ pump and ozone generator (if installed) run during
filtration (and may also run automatically at other times).
At the beginning of each filter cycle all other equipment will run briefly to purge the plumbing.
Optional Filter Cycle Programming
You are not required to change the filter cycles, but if you wish to, press "Time," "Mode/Prog,"
"Mode/Prog" within 3 seconds. SET START FILTER 1 (AM) will appear. Press "Warm" or "Cool" to
reset the filter start time. Press "Mode/Prog" to see SET STOP FILTER 1 and adjust the time with
"Warm" or "Cool" as done above. Press "Mode/Prog" to see SET START FILTER 2 (PM) and proceed
as above. Press "Mode/Prog" to see SET STOP FILTER 2 and proceed as above. Press "Mode/Prog"
to confirm.
Automatic polling (in Standard Mode only)
The pump will activate for 1 to 2 minutes to check the temperature:
- every 30 minutes
- whenever any other pump or blower is turned on
- whenever the set temperature is raised
Locking the Panel
Press "Time," "Blower," and "Warm" within 3 seconds. The Panel is now locked. To unlock the panel,
press the "Time," "Blower," and "Cool" within 2 seconds.
Locking the Temperature
Press "Warm," "Time," "Blower," and "Warm" within 3 seconds. The "Warm" and "Cool" buttons are
now disabled. To unlock the temperature, press "Time," "Blower," and "Cool" within 2 seconds.
Note: On some systems, "Jets 1," instead of "Blower," is used in Lock/Unlock sequences.
11