Setting Up The Spa - Passion Spas Renew Anleitung

3. Setting up the spa

Filling up your spa
You unpacked your new spa and checked thoroughly for possible damages. (Warn your
dealer immediately before installation of the spa if it has been damaged by transport.) You
placed your spa on the ideal location and met all the installation requirements. A certified
electrician connected your electricity.
Your Passion spa has been tested thoroughly for an optimal reliability and to guarantee a
long-term customer satisfaction. Remove the remaining water that may still be in the pipes
after factory testing from the spa. Make sure that the spa is completely clean before filling
it up.
• Always fill up the spa with tap water (drinking water) through the skimmer.
• Let the garden hose run for a minute before filling up the spa to prevent bacteria
from the water pipe and garden hose to get into your Passion spa.
• Do not fill up the spa with water with a higher temperature than 40° C. This could
cause an error in the high limit thermostat when turning on the spa.
• Fill up the spa when it is disconnected from electricity, use tap water and a hose.
• Switch on the tap and wait until the water level reaches 'Water Level'. The term
'Water Level' is marked in the middle of the skimmer (see drawing). This could take
some time, depending on your water pressure.
• When the water reaches "Water Level" (water level), turn off the tap and remove the
hose (exceeding the maximum water level could result to flooding of the spa).
• When operating the panels for the first time, check inside the machine area for leaks
(something could have come loose during transport) and close the panels again.
Operating the spa
You have met all the requirements to start the operating procedure.
• Check if all the jets are fully opened (see photo. The jets are closed
clockwise).
• Check if the filter cartridges are installed (see photos)
Pull the skimmer cover upwards to remove it
Remove the filter holder by pulling it forward from the drawer.
.
8