Passion Spas Renew Anleitung Seite 20

1) What to do when the total free bromine is too low?
•
use the push-button of the salt system to set the salt system to level 10.
•
Set the filter time to continuous.
•
If the total free bromide value is more than 2-3 ppm after 72 hours, lower the filter time
(Fil 8), so filter 8 hours per 12 hours.
•
If the total free bromide value is more than 2-3 ppm after 72 hours, lower the filter time
(Fil 6), so filter 6 hours per 12 hours.
•
If the total free bromide value is more than 2-3 ppm after 72 hours, lower the filter time
(Fil 4), so filter 4 hours per 12 hours.
•
If the total free bromide value is more than 2-3 ppm after 72 hours, twist the push-
button of the salt system back 1 level (from 10 to 9).
•
Subsequently repeat the testing every 72 hours and try to find a level for which the
bromide-value is not lower than 2 ppm and not higher than 3 ppm.
2) What to do when the total free bromine is too high?
•
Lower the filter time 2 hours to 23 hours (to minimally 4 hours per 12 hours).
•
If the value is still too high after 72 hours, continue to lower the filter time with 2 hours
per 12 hours.
•
Repeat this every 72 hours until the filter level is minimally 4 hours per 12 hours.
•
If the value is still too high after 72 hours, twist the rotary knob back 1 level.
•
Repeat this every 72 hours until a level is found for which the bromide-value is not lower than
2 PPM and not higher than 3 PPM.
3) What to do when the PH-value is too low?
•
Use PH+ if the value is below 7.0.
•
Thoroughly read the instructions on the package.
•
A PH balance that is too low could cause irritation to the eyes and damage to the spa.
4) What to do when the PH-value is too high?
•
Use PH- if the PH value is more than 7.5.
•
Thoroughly read the instructions on the package.
•
A PH balance that is too low could cause irritation to the eyes and the bromide to stop
working.
5) What to do when the alkalinity is too low?
•
use Total Alkalinity Control (TA+), if the alkalinity is below 80 PPM.
•
Contact your dealer first.
•
Read the instructions before use.
6) What to do when the alkalinity is too high?
•
Use PH- if the alkalinity is higher than 140 PPM.
•
Read the instructions before use.
7) What to do when the total lime content of the water is too low?
•
Use Calcium Booster if the total lime content of the water is lower than 100.
•
Read the instructions before use.
20