Passion Spas Renew Anleitung Seite 18

How to use your Aquacheck Test Strips:
(1)
(2)
(3)
(4)
Lime content tests, Alkalinity, PH and Bromide
•
Test the total lime content of the water. If the value is under 100, add calcium
Booster, see number (1). Read the instructions before use.
•
Test the alkalinity of the water. The ideal alkalinity is between the values 80 PPM and
140 PPM, see number (3). If the value is above 140 PPM, use PH-. If the value is below
80 PPM, use Total Alkalinity Control (TA=) (contact your dealer). Read the instructions
before use.
•
Test the total lime content of the water.
7.5, see number (4).
the water is more than 7.5, use PH-. Thoroughly read the instructions on the
package. An incorrect PH balance could cause irritation to the eyes and damage to
the spa.
•
When using the spa intensively we advise you to use the Boost button. This will
temporarily release extra Bromine to keep the water crystal clear.
1. Dip the strip into the water and take it out again
2. Hold the strip horizontally for 15 seconds
3. Compare the colours
The ideal values : between 100 and 500
The ideal values: between 2 and 3
The ideal values : between 80 and 140
The ideal values : between 7,0 and 7,5
The ideal PH-value is between 7.0 and
If the PH of the water is under 7.0, use PH+. If the PH of
18