Passion Spas Renew Anleitung Seite 17

SALT SYSTEM MANUAL
Required materials:
- Salt TRU-BLU.
- Test strips sodium bromide.
- Test strips aquachek total bromine.
- PH-
- PH+
Salt addition table
Type Tru-Blu (gram)
Passion spas
Renew 1700
Refresh 2760
Relax 2600
Pleasure 2070
Happy 2480
Admire 3472
Sunny 3360
Bright 3440
Fill up the spa with water and add the indicated amount of salt.
Go through the normal start up procedure of the spa. Switch on the jet at a high speed.
Add TRU-BLU to the water with a dosage of 2 grams per litre. Apply evenly to the water.
Leave the jet on for 15 minutes at a high speed.
Test the amount of salt in the water by using GENESIS SODIUM BROMIDE test strips. The ideal
values are between 7,8 and 8,0. Carry out this test once every two months.
This test is carried out as follows:
•
Take a cup, fill it with approximately 2,5 cm of water from the spa.
•
Take a sodium bromide test strip and put it in the cup with the yellow edge pointing upwards.
•
Wait until the yellow edge turns black and read the values. The ideal values are between 7,8 -
8.
•
By adding one lid full of TRU-BLU, the sodium bromide values will increase about 0,4.
17