Troubleshooting - Passion Spas Renew Anleitung

12. Troubleshooting

The spa does not switch on

Is it plugged in?

Is the fuse still in?
If so, is earth switched 'on'? Consult an electrician or your Passion Spas dealer if the fuse/earth comes
off several times.
The jet produces a sound, but does not build up pressure
Does the water at least reach the middle of the skimmer (water level)?
If not, fill the spa up with some more water. It is possible that an air bubble was created in the system
when filling up the spa. Press 'on' and 'off' on the same jet a couple of times and/or let some of the
water/air escape by draining the spa.
The spa produces a slurping sound
The water probably does not reach up halfway to the skimmer. Add water until the water level is
reached.
The water pressure switches from heavy to light
The water probably does not reach up halfway to the skimmer. Add water until the water level is
reached.
It is more difficult to keep the water clean than before
- Read the chapter on Water Maintenance thoroughly.
- The total of dissolved substances is more than 1500 ppm. Change the water.
- The ozonator could be broken.
The best way to check this is in the dark. Remove the panel and look for a cylindrical-shaped black
apparatus, with a diameter of 6 cm and a length of 25 cm. If it glows, the ozonator is still working.
Consult your dealer when it does not glow.
The spa does not turn off
The spa is in the middle of heating or filtering, it cannot be switched off then.
The blower sometimes suddenly turns on by itself, then it stops after a while.
A certain program of the spa initiates this process. It prevents bacteria from growing if the water is
stagnant for too long.
29