Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Englisch
2.6.2 maintenance and inspection
CAUTION!
· When cleaning the exterior box of the voltage amplifier, first turn off the power switch and unplug the power
plug. Failure to observe these items may result in a fire or electrical shock.
Cleaning the exterior box using a firmly wrung-out cloth. Do not use alcohols, benzene, paint thinner or other
inflammable substances. If flammable substances come into contact with a electrical component inside the
voltage amplifier, this may result in a fire or electrical shock.
2.6.3 instructions for checking the function of the system / quick start
When you open the package, please check to make sure all the necessary parts are complete (see packing
list) and nothing is damaged.
Check the electronics and the actuator for any visible damage:
· The top and bottom plate of the actuator (if it does not have another shape) should be parallel each to each
other, without scratches.
· If there is any damage to the system please contact our local representative immediately!
· If the packaging material is damaged please confirm this with the shipping company.
Before you switch on the system, please check:
· The main voltage supplied in your country is the same as installed for the system. (Check the voltage label
on the backside of the power supply)
· The power switch should be in the off position
· Connect the power supply.
· Connect the piezo actuator by using the D-SUB15pin connector. Be sure the cables are connected properly
to the electronics.
2.6.4 environmental conditions
The amplifier can be used:
· indoor
· altitude up to 2000 m
· temperature: 5 ... 35 °C
· relative humidity: 5 ... 95% (non-condensing)
recommended environmental conditions:
· indoor
· altitude up to 2000 m
· temperature: 20...22 °C
· relative humidity: 5 ... 80% (non-condensing)
2.7 how to operate the voltage amplifier
2.7.1 overview
The voltage amplifier nano box USB has been developed as a universal solution for single-channel positioning
with low dynamics. An internal digital drift compensation controller allows the use of closed loop of the
D-Series actuators. The measurement system is only supported DMS.
53
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezojena.com
Werbung
Inhaltsverzeichnis
