Product Disposal - Zelmer ZIR3210 Benutzerhandbuch

AF-MANUAL_Plancha-ZIR3210 performance.pdf
EN
TROUBLESHOOTING
PROBLEM
SOLEPLATE IS NOT HEATING
EVEN THOUGH IRON IS
TURNED ON.
IRON DOES NOT PRODUCE
STEAM
C
SPRAY FUNCTION DOES NOT
WORK
M
Y
STEAM JET AND VERTICAL
STEAM JET FUNCTION DOES
CM
NOT WORK
MY
CY
CMY
K
THE IRON LEAKING
WHITE STREAKS COME
THROUGH THE HOLES IN THE
SOLEPLATE

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the electri- cal
and electronic waste collection centre closest to your home.
We hope that you will be satisfied with this product.
14
14 8/4/21
POTENCJALNA PRZYCZYNA
Connection problem
Temperature control is in MIN
position
Not enough water in tank
Steam control is selected in non-
steam position.
Selected temperature is lower than
that speci ed to use with steam.
Not enough water in tank
Steam jet function was used very
frequently within a short period.
Iron is not hot enough
The temperature setting is too low
to produce steam.
The soleplate has a build-up of
scale because it has not been
self-cleaned regularly.
15:09
ROZWIĄZANIE
Check main power supply cable, plug
and outlet.
Select adequate temperature
Fill water tank
Set steam control between positions
of minimum steam and maximum
steam (see"iron chart").
Select a higher temperature
Fill water tank.
Put iron on horizontal position and
wait before using steam jet function.
Adjust to higher temperature to
steam ironing. Put iron in vertical
position and wait temperature
indicator light becomes xed.
The variable steam knob must be set
on"0"position until the iron is hot.
Do the self-cleaning process.
Remember to do it at least every
two weeks.