Filling With Water; Maintenance And Cleaning; Advise On Disposal - Zelmer ZGS1100 Benutzerhandbuch

PL EN

Filling with water

Remove the mains plug from the wall socket before filling (or emptying) the garment.
Steamer with water
Press the 2 buttons at the same time to remove the water tank and pull out the water tank.
Remove the water inlet stopper. Fill the water tank with a maximum of 325 ml of untreated tap water.
Your appliance was designed to operate using untreated tap water.
Do not use pure demineralised or pure distilled water, water from clothes dryers, scented or softened
water, rain water, filtered, bottled or boiled water, water from refrigerators, batteries or air conditioners
as these may damage the appliance. These types of water contain organic waste, mineral elements that
become concentrated when heated and cause spitting, brown staining, leaking or premature wear on
your appliance. If your water is very hard, mix 50% untreated tap water with 50% distilled water.
Close the water inlet stopper.
Return the water tank to its place on the appliance then plug it in.

MAINTENANCE AND CLEANING

After use it, please remove the water tank, empty the water tank completely, and then return the water
tank to its place.
Before cleaning the garment steamer ensure it is unplugged from the power supply and has completely
cooled down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as
these will damage the surface.

ADVISE ON DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the
electrical and electronic waste collection centre closest to your home.
We hope that you will be satisfied with this product.
8