Troubleshooting; Product Disposal - Zelmer Stiro ZIR3000 Benutzerhandbuch

AF-MANUAL_Plancha-ZELMER ZIR3000 stiro.pdf
EN

TROUBLESHOOTING

PROBLEM
SOLEPLATE IS NOT
HEATING EVEN THOUGH
IRON IS TURNED ON.
IRON DOES NOT PRODUCE
STEAM
C
M
SPRAY FUNCTION DOES
NOT WORK
Y
CM
STEAM JET AND VERTICAL
STEAM JET FUNCTION
MY
DOES NOT WORK
CY
CMY
K
STEAM JET AND VERTICAL
STEAM JET FUNCTION
DOES NOT WORK

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the electri- cal
and electronic waste collection centre closest to your home.
We hope that you will be satisfied with this product.
14
14 12/4/21
POSSIBLE CAUSE
Connection problem
Temperature control is in MIN
position
Not enough water in tank
Steam control is selected in
non- steam position.
Selected temperature is lower
than that speci ed to use with
steam.
Not enough water in tank
Steam jet function was used
very frequently within a short
period.
Iron is not hot enough
Steam jet function was used
very frequently within a short
period.
11:38
SOLUTION
Check main power supply cable,
plug and outlet.
Select adequate temperature
Fill water tank
Set steam control between
positions of minimum steam
and maximum steam (see"iron
chart").
Select a higher temperature
Fill water tank (see "getting
started", no 2).
Put iron on horizontal position
and wait before using steam jet
function.
Adjust to higher temperature to
steam ironing. Put iron in
vertical position and wait
temperature indicator light
turns o .
Put iron on horizontal position
and wait before using steam jet
function.