Dry Ironing; Shot Of Steam; Vertical Ironing - Zelmer ZIR3210 Benutzerhandbuch

AF-MANUAL_Plancha-ZIR3210 performance.pdf
EN
become fixed and you will hear an acoustic sound.
Set the variable steam control to the desired position.
The appliance has an intelligent steam control that will automatically control the variable steam to make
sure its according to the temperature level selected. This means that even the variable steam control is set
in high position, if the temperature level is in low position the appliance will automatically regulate steam to
be according to the temperature level to avoid damaging clothes.
CAUTION: Avoid coming in contact with ejected steam.

DRY IRONING

The steam iron can be used on the dry setting with or without water in the water tank, it is best to avoid
having the water tank full while dry ironing.
Turn the variable steam control to the minimum position.
Select the setting on the temperature control dial best suited for the fabric to be ironed.
CAUTION: If the steam iron has been used for a long time, it is hot and there is no water. Do not refill it
with water until the steam iron cools down.

SHOT OF STEAM

The shot of steam feature provides additional steam for removing stubborn wrinkles. Turn off the variable
C
steam control to the min position
M
Press the powerful steam button to release the burst of steam.
Y
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button in continuously
and wait almost 5 seconds between pressures.
CM
MY

VERTICAL IRONING

CY
By pressing the shot-steam button at intervals you can also iron vertically (curtains, hung garments, etc.)
CMY
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button in continuously
and wait almost 5 seconds between pressures.
K
WHEN YOU FINISHED IRONING
Set the temperature dial to the minimum position. Remove the main plug from the wall socket.
Stand the iron on heel rest.
MANITENCE AND CLEANING
It is recommended to the self-cleaning every two weeks if the water in the area is hard or semi-hard if
frequent use of the device is made
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled
down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as these
will damage the surface.
Cleaning the soleplate; Do not use scouring pads or harsh cleaners on the soleplate as these will da- mage
the surface. To remove burnt residue, iron over a damp cloth while iron is still hot. To clean the soleplate,
simply wipe with soft damp cloth and wipe dry.
12
12 8/4/21 15:09