Anti-Calc System; Auto Shut-Off - Zelmer ZIR3210 Benutzerhandbuch

AF-MANUAL_Plancha-ZIR3210 performance.pdf
SELF-CLEANING
Fill the half of the water reservoir.
Set the temperature control to its maximum position. Insert the main plug into the wall socket.
Allow the iron to heat up until the indicator light becomes fixed. Unplug the steam iron.
Holding the iron horizontally over the sink and press the button of Self clean, in case if not have this button
change the steam control to the maximum position.
Boiling water and steam will be ejected from the holes in soleplate with impurities washed out Move the
iron over an old (preferably) piece of cloth. This ensures that the soleplate will be dry during storage. Is
recommended to do the self-cleaning at least every two weeks.

ANTI-CALC SYSTEM

A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate.
The resin filter is permanent and does not need replacing.
Please note: Do not use chemical additives, scented substances or decalcifies. Failure to comply with the
above-mentioned regulations leads to the loss of guarantee.

AUTO SHUT-OFF

C
An electronic safety device will automatically switch the heating element off if the iron has reached the
temperature selected and the handle sensor is not touched for more than 10 seconds approximately in a
M
horizontal position. If in a vertical position, this will happen after 10 seconds approximately, too, provided
Y
selected temperature is reached and handle sensor is not touched. To indicate that the heating element
has been switched off, the auto-off pilot light will start blinking.
CM
When picking up the iron again, the auto-off pilot light will turn off. The power pilot light will turn on. This
MY
indicates that the iron is heating up again.
CY
Wait for the power pilot light to become fixed, then the iron is ready for use.
CMY
SENSE TECHNOLOGY
K
The iron handle incorporates a sensor that, when the variable steam is selected, will turn on the variable
steam function while the hands touches the handle form the upper part. If the iron is not touched the
variable steam function will be stopped.
INJECTION STEAM
The appliance has an injection steam system that injects water to the soleplate in order to facilitate a
greater penetration of steam into the garments. You will notice this function as a small vibration when
product is working under steam ironing function.
13 8/4/21 15:09
EN
13